Electrospinning Synthesis and Photoluminescence Properties of SnO2：xEu3＋ Nanofibers

NnO2：xEu3＋（x=O, 1%, 3%, 5%, molar fraction） fibers were synthesized by electrospinning technology. The size of the as-prepared fibers is relatively uniform and the average diameter is about 200 nm with a large draw ratio. The as-prepared Eu3＋ doped SnO2 nanofibers have a rutile structure and consist of crystallitc grains with an average size of about 10 nm. A slight red shift of the A1gand Bag vibration modes and an additional peak at 288 nm were observed in the Raman spectra of the nanofibers. The energies of bandgaps of the SnO2 nanofiber with Eu doping of 1% and 3% are 2.64 eV, and the energy of bandgap is 2.94 eV with Eu doping of 5%（molar fraction）. There is only orange emission（5D0→7F1 magnetic dipole transition） for Eu doped SnO2 nanofibers, and no red emission could be observed. The orange emission upon indirect excitation splits into three peaks and the peak intensity at the excitation wavelength of 275 nm is higher than that at the excitation wavelength of 488 nm.     

Effect of emitter layer doping concentration on the performance of silicon thin film heterojunction solar cell

A novel type of n/i/i/p heterojunction solar cell with a-Si:H(15 nm)/a-Si:H(10 nm)/ epitaxial c-Si(47 μm)/epitaxial c-Si(3 μm) structure is fabricated by using the layer transfer technique, and the emitter layer is deposited by hot-wire chemical vapour deposition. The effect of the doping concentration of emitter layer S_d (S_d=PH₃/(PH₃+SiH₄+H₂)) on the performance of the solar cell is studied by means of current density-voltage and external quantum efficiency. The results show that the conversion efficiency of the solar cell first increases to a maximum value and then decreases with S_d increasing from 0.1% to 0.4%. The best performance of the solar cell is obtained at S_d = 0.2% with an open circuit voltage of 534 mV, a short circuit current density of 23.35 mA/cm², a fill factor of 63.3%, and a conversion efficiency of 7.9%.     

Li-S电池硫正极性能衰减机理分析及研究现状概述

由于汽车工业的持续发展, 对高能量密度二次电池的需求逐步增加, 锂硫电池开始走进人们的视野. 锂硫电池的理论比能量高达2600 Wh/kg, 而单质硫的理论比容量达1680 mAh/g. 同时, 硫的储量丰富, 廉价, 并且环境友好. 虽然可充电锂硫电池相比于传统锂离子电池有诸多优势, 但目前其可实现的实际比容量远低于理论比容量, 循环寿命也较短等弊端限制了其大规模应用. 作者从Li-S电池正极的工作原理出发, 对硫正极容量损失及衰减机理做了深刻的解析, 并结合本实验室的工作归纳总结了导致硫正极容量衰减的主要因素. 针对硫正极容量衰减因素, 从碳导电结构、聚合物包覆以及纳米金属氧化物添加剂等方面, 对近年来提高硫正极性能的主要研究方向及最新研究进展进行了综述, 并对其中存在的问题进行分析, 最后对提高Li-S电池的整体性能提出展望.     

碳掺杂的二氧化钛纳米管的制备及其可见光催化性能

以尿素作为碳元素前驱体对TiO2纳米管进行掺杂,采用比表面积测定、X射线衍射、透射电子显微镜、能量色散X射线荧光光谱、X射线光电子能谱、固体漫反射紫外-可见吸收光谱和荧光光谱对产物进行了表征。 结果表明,以尿素作为前驱体可制备C掺杂的TiO2纳米管,C掺杂后,TiO2纳米管的可见光催化活性明显提高。 此外,研究了C掺杂量、煅烧温度、催化剂用量和pH值对TiO2纳米管光催化降解活性的影响,发现当C的掺杂量为5.3%、催化剂用量为1.5 g/L、溶液的pH值为5时,在其催化作用下,可见光光照3 h后罗丹明B的降解率可达到91%。     

锂离子电池正极材料Fe3+掺杂Li1+xV3O8的制备与电化学性能

采用柠檬酸辅助的溶胶-凝胶法制备了Fe^3＋掺杂Li1.1Fe0.05V2．95O8及对比样品LiV3O8正极材料．使用TG—DTA、XRD、FT-IR等手段表征了正极材料的物理化学特性,并采用EIS、恒电流充放电等手段研究了其电化学性能．结果表明：Fe^3＋掺杂LiV3O8与对比LiV3O8相比,能在更低的温度下晶化,能在相同温度、相同时间煅烧下保持更小的晶粒度．Li1.1Fe0.05V2．95O8与对比LiV308相比,特别是大电流下的放电容量有较大的提高,在75mA·g^-1,197mA·g^-1,373mA·g^-1及重新回到75mA·g^-1电流下的初始放电容量分别是307mAh·g^-1,237mAh·g^-1．162mAh·g^-1和302mAh·g^-1．在回复到75mA·g^-1电流后放电容量能非常稳定保持在278．6mAh·g^-1左右,并同时给出了初步的理论解释．     

The modulation effect of substrate doping on multi-node charge collection and single-event transient propagation in 90-nm bulk complementary metal-oxide semiconductor technology

Variation of substrate background doping will affect the charge collection of active and passive MOSFETs in complementary metal-oxide semiconductor (CMOS) technologies, which are significant for charge sharing, thus affecting the propagated single event transient pulsewidths in circuits. The trends of charge collected by the drain of a positive channel metal-oxide semiconductor (PMOS) and an N metal-oxide semiconductor (NMOS) are opposite as the substrate doping increases. The PMOS source will inject carriers after strike and the amount of charge injected will increase as the substrate doping increases, whereas the source of the NMOS will mainly collect carriers and the source of the NMOS can also inject electrons when the substrate doping is light enough. Additionally, it indicates that substrate doping mainly affects the bipolar amplification component of a single-event transient current, and has little effect on the drift and diffusion. The change in substrate doping has a much greater effect on PMOS than on NMOS.     

Structures of Pt clusters on graphene doped with nitrogen, boron, and silicon: a theoretical study

The structures of Pt clusters on nitrogen-,boron-,silicon-doped graphenes are theoretically studied using densityfunctional theory.These dopants(nitrogen,boron and silicon) each do not induce a local curvature in the graphene and the doped graphenes all retain their planar form.The formation energy of the silicon-graphene system is lower than those of the nitrogen-,boron-doped graphenes,indicating that the silicon atom is easier to incorporate into the graphene.All the substitutional impurities enhance the interaction between the Pt atom and the graphene.The adsorption energy of a Pt adsorbed on the silicon-doped graphene is much higher than those on the nitrogen-and boron-doped graphenes.The doped silicon atom can provide more charges to enhance the Pt-graphene interaction and the formation of Pt clusters each with a large size.The stable structures of Pt clusters on the doped-graphenes are dimeric,triangle and tetrahedron with the increase of the Pt coverage.Of all the studied structures,the tetrahedron is the most stable cluster which has the least influence on the planar surface of doped-graphene.     

Ce掺杂ZnO纳米晶的光催化性能研究

以Zn( NO3)3·6H2O、Ce( NO3)3·6H2O为原料,明胶为模板分散剂,采用凝胶模板燃烧法制备纯ZnO和Ce/ZnO纳米晶,利用XRD、TEM、BET、UV-Vis漫反射进行表征.以染料罗丹明B为目标降解物考察了样品的光催化活性.结果表明:产物粒子形状基本为球形,结晶良好,属六方晶系结构.相比纯ZnO,Ce/ZnO对光具有更高的吸收利用率,在紫外和可见光下对罗丹明B的降解能力均有明显提高;随Ce掺杂量的增加,样品的粒径减小,比表面积增大,罗丹明B的降解率相应增大,在紫外和可见光下降解率分别可达98.6;、78.3;,其原因在于Ce掺杂有利于在ZnO纳米粒子中心和表面之间产生电势差,实现光生电子-空穴对的有效分离.     

ZnFe2O4/Ag/TiO2复合材料的制备及其光催化性能

以硝酸银、钛酸四丁酯、无水氯化锌、六水氯化铁为原料,采用溶胶-凝胶法与溶剂热相结合的方法制备了ZnFe₂O₄/Ag/TiO₂复合材料,通过扫描电子显微镜、能谱分析仪、X射线粉末衍射仪、X射线光电子能谱仪、振动样品磁强计、紫外可见分光光度计对样品进行表征及测试。结果表明：ZnFe₂O₄/Ag/TiO₂-10具有最佳的光催化效果,在紫外和可见光下对染料的降解率都能达到90%以上,具有优异的紫外可见光光催化活性。ZnFe₂O₄/Ag/TiO₂具有独特的磁性,能在外部磁场作用下进行回收利用,这使其在实际应用中成为可能。通过磁分离技术重复回收利用5次后仍然保持优良的光催化性能,说明ZnFe₂O₄/Ag/TiO₂-10具有优异的磁性及较高的光催化循环稳定性。     

N掺杂空心TiO2微球的合成与表征

采用无皂乳液聚合合成的聚苯乙烯(PS)微球为模板、氨水/三乙醇胺为催化体系, 通过溶胶-凝胶方法合成了PS/TiO₂(核/壳)复合微球, 然后通过煅烧制备了N掺杂、锐钛型空心TiO₂微球. 在反应体系中三乙醇胺扮演双重角色, 既是TiO₂生成及包覆过程的抑制剂又是空心TiO₂微球的N掺杂剂. 改变氨水、三乙醇胺和钛酸正丁酯用量可控制TiO₂壳的形态和尺寸. 氨水用量增加, PS/TiO₂复合微球的壳表面变得粗糙|三乙醇胺用量增加, 壳表面变得光滑|钛酸正丁酯用量提高导致壳层变厚. 改变三乙醇胺用量可调节空心TiO₂微球中的N掺杂量|N掺杂空心TiO₂微球具有可见光响应和光催化作用.